|Title||The working principle of candy cutting machine|
|Description||Before starting the automatic oil press, all auxiliary appliances and containers should be prepared, and the elasticity of the transmission belt should be checked and adjusted. Then turn on the motor, run the machine idling for about 15 minutes, and check the speed of the screw shaft. The normal speed should be around 33dmin. When idling, pay attention to the meshing condition of the gears in the gearbox and whether the sound is normal fruit juice machine, whether the bearing parts and the motor are normal. When the oil press is idling, the motor current should be about 3A. If the current is too high, stop and check immediately, and restart after adjustment. The oil press is a machine that continuously advances the blank in the press chamber and extracts crude oil under the action of dynamic extrusion. In addition to the feeding hopper, the press chamber is the main part of the operation. It consists of a screw shaft and a cylindrical press cage. There are two ways of single-stage pressing and double-stage pressing. Single-stage only needs one horizontal pressing chamber, and two-stage other Add a straight press chamber to stop the first press. The squeezing screw shaft consists of a number of squeezing screws and pitch rings sleeved on the shaft. Each press screw has a certain pitch and screw depth, and the pitch of each press screw on a shaft is gradually shortened from the inlet to the outlet, and the screw depth gradually becomes shallower, so that the volume of the press chamber is gradually changed from the inlet to the outlet candy cutting machine. Decrease, after the billet enters the press chamber, it advances along the snail stage to the exit, and the pressure on it gradually increases, thereby gradually squeezing out the oil. A gasket is installed between the sliver and the sliver of the cylindrical press cage of the screw press to form an oil gap, and the squeezed crude oil flows out through the gap. Don’t feed the material too fast at the beginning of the squeeze, otherwise the pressure in the press chamber will suddenly increase cake making machine, and the press screw cannot rotate, causing a blockage in the press chamber, and even breaking the press cage, causing a serious accident. Therefore, when the contraction begins, the feed should be slowly fed into the hopper to stop the oil press from running in. Repeat this repeatedly for more than 3 to 4 hours, so that the temperature of the oil press gradually rises, so that the temperature of the press chamber is low when the green smoke begins to press, and it can be turned slowly. The handle on the joint stud increases the thickness of the cake. At the same time, the water content of the pressing material will be increased, and the temperature of the pressing chamber will be waited. When the temperature rises to about 90°C, after the oil press works normally, the oil press can adjust the cake thickness to 1.5～2.5mm, and tighten the fastening nut.|
Please register or log in.