|Title||Notes of Cone Crusher Lubrication Process|
|Description||(one) The lubricating oil goes in to the Quarry Crusher by two paths. A person goes in in the bottom oil hole of cone crusher, after which divides into 3 instructions to the inside and outside of your hollow eccentric shaft, the middle oil hole with the major bearing as well as bowl kind bearing, experiencing the opening lubricating huge and little equipment, after which you can the oil will return with the base oil returning hole with the little bevel gear. The opposite oil route is within the hole of your driving bearing shelf, lubricating the driving bearing, and its oil returning can also be with the oil returning gap from the modest bevel gear as well as the defend. The oil returning goes back again for the oil box from your solitary oil pipe. (2) If you want for your normal perform of cone crusher, when there's no heating gear within the plant in winter, an electric resistance heater is set up inside the oil box as a way to make improvements to the temperature with the oil; in summer season, when the temperature from the oil raises, the customer can lubricate the equipment creating the oil undergo the listen to exchanger. (three) Thanks to extensive time of operating, the temperature of your lubricating oil will raise, but it can in no way be larger than 60℃, otherwise, the worker should really fast stop the cone crusher and look at the reasons and remove the fault. (four) The oil tension will have to achieve 0.8-1.5kgf/cm2. Only if the lubricating oil reaches its lubricating place, can the principle motor be started out. If your oil stress is below 0.8kgf/cm2, the control method on the equipment will ship a signal and immediately cease feeding components, at this time, the employees will have to learn the key reason why and take care of the trouble. (five) The tension on the water intending to the heat exchanger is usually 2-3kgf/cm2, as well as temperature going to the commutator need to be under 28° and also the water ought to be clean. (6) In winter, in the event the cone crusher is not doing the job for several hours, the worker must take proper measures to prevent the oil box along with the oil within the oil pipe from freezing. The best way is to run without supplies in it. When necessary, the resistive heater inside of the oil box can be used. (7) The filter should really be always kept clean. Should the amount of your oil decreases, which may be caused by oil net blockage, right now, the device ought to be stopped and repaired. When cleansing the pipe on the lubricating technique, the place there exists likely sediment and smug must examined, such as the knee of your pipe, and make sure cleansing the whole oil pipe or part on the pipe according towards the examining result. (8) When the lubricating procedure is not doing the job, the oil level while in the oil container really should arrive at above the upper limit; in the event the lubricating technique is operating, the oil level in the oil container must not be lower than the lower limit. The examination, cleansing and repair from the oil box really should not less than once ever year. As a professional as well as the best mining machinery manufacturer in China, We is always ready to provide the superior dryer device with the best quality as well as most competitive price.|
Please register or log in.